Product info form

Cena	45.00 EUR
Kods	PS5

Ielikt grozā

Nav noliktavā

šobrīd nav pieejams

Izvēlaties variantu

Suņu pretriešanas siksna ar vibrācijas funkciju un elektro impulsu, vadāma ar pulti suņa apmācībai un kontrolei.

Darbības rādiuss līdz 270 m

Vairāku līmeņu vibrācijas un elektroimpulsa funcijas regulējams ar pults palīdzību.
Tā kā šai ierīcei ir abas - elektroimpulsa un vibro funkcijas, tad tā ideāli derēs kā kucēnu, tā arī jau pieaugušu suņu apmācībai.

Siksnas apkārtmērs ir regulējams.

Komplektācijā ietilpst 2 izmēru kontakti - īsāki un garāki - piemērojami attiecīgi sunim ar īsāku vai garāku spalvu.
Siksnas nav zemūdens izturīgas, ar tām suns nevar IET PELDĒTIES

100 levels of vibration.

100 levels of static (optional).

The levels can be altered by use of up & down button.

A tone button activates a tone on the receiver.

This system is used for 2 receivers.

The receiver will TURN OFF if it is unused for 4 minutes.

Any movement will activate the receiver into STANDBY MODE.

The transmitter will go into STANDBY MODE if there is no operation after 20 seconds and turn off after 2 minute.

Adjustable belt length, maximum diameter of 18cm, two pairs of metal prong (short/long) to suit dogs with varied fur thickness.

User Manual for Transmitter:

To install the batteries, open the battery cover, which is at the back of the transmitter.

Install the battery (2 x 4LR44/ 6V) in the transmitter and ensure the polarity is correct.

The transmitter will be TURN ON automatically.

Press the buttons one by one - the LCD images will change.

Press the up and down buttons on right hand side to set level. .

The LED light can be used for giving training signals.

The transmitter will go into STANDBY MODE if not operated for 20 seconds and will TURN OFF if not operated for 2 minutes.

In STANDBY MODE, press any button (except LED light button) to wake it up.

To TURN ON the transmitter, hold mode button for at least 5 seconds.

User Manual for the Receiver:

To install the batteries

Remove the cover

Install the batteries (2xAAA 1.5V), make sure the polarity is correct

There is a beep right after installing the batteries in the receiver

Go to the transmitter and choose 1 or 2 channel to encode by pressing the channel button 1/2 in the transmitter

Then press the LAUNCH button on transmitter immediately

The receiver will beep - it is now encoded to the transmitter

Replace cover and tighten metal probes

Atpakaļ